100 litre wax steam boiler with Lyso® stove.

Quantity

- +

Steam wax extractor or certifier made of stainless steel . It consists of a 0.6 mm thick stainless steel body, measuring 520 mm in diameter and 630 mm in height, and comes complete with a lid and handles. Designed to work with a gas stove.
The tank is hermetically sealed and 100 mm high for the water reservoir. The 18/10 stainless steel filter, measuring 480 mm in diameter and 530 mm in height, is located inside the drum. It has a 100-liter capacity.
The connecting siphon allows steam to pass from the tank to the upper drum. It holds approximately 18 Langstroth frames; it can also be used with other frame models.
Gas stove not included.

Instructions for use:

• Place the squares that need to be melted or cleaned inside the certifier.
• Close the lid with its closing clamp (never use a hermetic seal).
• Fill the bottom of the cerifier through the water filling tube.
• Close the water introduction tube with a cloth (never a hermetic plug).
• Place the cerifier on a heat source such as a gas burner or stove (not included).
• Once the water boils, steam is produced and rises through the siphon and melts the wax on the frames. The melted wax comes out through the outlet tube.

Please note:

• Wash with hot water and detergent before use.
• NEVER close the lid tightly.
• NEVER close the water introduction tube tightly or using a plug.
• Regularly check the water level in the false bottom. If it runs out of water, it will burn.
• If you don't see water in the feed tube, it means the bottom is empty and it must always have water during use.

Technical characteristics:

• Brand: Lyson ®.
• Lyson reference: W4097P_BT.
• Material: Stainless steel.
• Cylinder sheet thickness: 0.6mm.
• Bottom thickness: 0.8mm.
• Boiler volume: 100 liters.
• Average diameter: 520mm.
• Body height: 630mm.
• Water capacity: 20 liters.
• Inner basket dimensions: Ø480x530h.

Compatible accessories:

• Four-legged gas stove for wax boilers.
• Three-legged gas stove for wax boilers.

Note: A wax melting process takes approximately 20-30 minutes, depending on the texture and condition of the honeycombs and the outside temperature of the environment.

User manual.
Number of frames they hold.