Drilling machine type manual press frames.

Quantity

- +

It is designed to make holes in the side bars of frames before nailing them vertically or horizontally as if it were a press and at the same time put the eyelets.
It is screwed to the work table with several wood tapping screws or it can even be screwed to an iron table with Din 933 or 931 screws and their Din 934 or DIN 985 nuts.

How to use:
Lower the lever of the device and make the holes with a diameter of 1.8mm.
Very little effort is made as it works like a press by the law of the lever.
The holes are fixed, you can make 5 holes for the dadant camera frame, 4 holes for the langstroht frame and 3 holes for the dadant or half langstroht rear frame.

Click to see detail
Click to see detail
Click to see detail