Select size / variety:...D52cmD64cm Quantity

Manual transmission for extractor with crank with steel gears with brake for a longer duration over time, including a bar with side holes to screw to the honey extractor drum with two M8 screws.
With housing and frame made of cast aluminium.
For 16 mm diameter cage cage axle and coupled below the bar.
The casing inside where the gears are housed has grease and a watertight seal to prevent losses. Every year it is good to check and put a little grease if necessary, especially in very hot places.
The brake is activated by turning the crank in the opposite direction to the rotation of the extractor.
Two models, one for a 52 cm honey extractor and another for a 64 cm honey extractor.

Characteristics:

• Gear material: Case-hardened hardened steel.
• Colour: Lacquered blue.
• Shaft material: Carbon steel.
• Crank: Cast aluminum.
• Housing: Cast aluminium.
• Inner diameter bushing: 16mm.
• Cap height: 40mm.
• Distance between screws: 70mm.
• Shaft diameter: 16mm.
• Coupling type: Below bar.
• Bar section: 40x10mm.
• Models: D52cm and D64mm.

Note: The transmission is shipped with the lever placed in the inside position to take up less space in transport, you have to remove the lever with the crank and turn it over and tighten the allen screw, the bar is screwed from the side to the top edge of the extractor with two M8 screws.

Click to see detail
Click to see detail