Engine carrier bar or manual transmission made of stainless steel, it is the central bar that runs through the center of the extractor and serves as a support for the engine or manual transmission and also for the covers.
With two 45mm collipsed holes at the ends for mounting on the drum by means of two M10 angled screws.
With a 24mm diameter central hole in the center and 4 holes to mount the engine in parallel or perpendicular position and also two holes to mount the manual transmission.
Available in three models:- Model M1: Drums from 600 to 650mm.
- Model M2: Drums from 485 to 550mm.
- Model M3: Drums from 430 to 485mm.
Characteristics:- Material: Stainless steel.
- Flat section: 40x8mm.
Click to see detail